How to Reset Error Code E08 in Canon MP287 - Absorber Full

When the MP287 is turned on, it will immediately appear on the LCD panel error E08 MP287. And when we do print command, then the monitor screen will show “The Ink Absorber is Almost Full”. Caption MP287 E08 error on the screen as follows:

1. Turn on the Canon MP287, MP287 LCD then the panel will pop up error E08, and there is a description of “The Ink Absorber is Almost Full” on the screen of your monitor.
2. Download Resetter MP287 at this link
3. Canon MP287 printer must be in a state of SERVICE MODE. Do I read the next step.
4. Canon MP287 Turn off the E08 error by pressing the power. Do not unplug the power cord.
5. Press and Hold the button STOP / RESET followed by pressing the POWER button. So both buttons depressed position.
6. Release the button STOP / RESET but do not release the button POWER.
7. In these circumstances the POWER button is still depressed, press the STOP / RESET 6 times.
8. Then release both buttons simultaneously. Then the Canon MP287 will be in Service Mode condition.
9. LCD Panel MP287 will blank / dark and in your computer will detect new hardware. Ignore it.
10. The next step Exctract and Run Service Tool for MP287 MP287 E08 error you downloaded earlier.
11. Click the “PLAY”, then the printer will proceed, then MP258 will print one page with the words “D = 000.0″
12. Click “Clear EEPROM”.

13. Then click “EEPROM”, and the printer will print the results MP258 Resetter. Writing one line as follows: “TPage (COPY TTL = 00 000 = 00 000)”.
14. Canon MP287 Turn off by pressing the power.
15. Canon MP287 printer that error E08 will be normal again.

Read More...

Any Kind of Canon Printer Problems Call Us
+1-855-517-2433 (Toll Free)

Printer Canon Pixma MP258 – Absorber Full

Printer Canon Pixma MP258 – Absorber Full

If your printer show P07 error it means that your ink absorber inside the printer is almost full. In order to solve this you need to clear or reset the counter protection of your printer. To do this, follow this steps.

First make sure that the power cable and usb cable are connected, before you perform the reset procedure. And download the resetter at the bottom of this post.

FIRST STEPS:  Entering Service Mode

You have to enter in service mode in order to used the resetter. To do that follow this procedure,

1. Turn off the printer without pulling the power cords.

2. Hold down STOP/RESET button and press Power button.

3. Keep holding down Power button and let STOP/RESET button go.

4. Then Press STOP/RESET button twice then let BOTH buttons go.

5. You will notice that the Alternate Blinking error is gone, this means that the printer is in Service Mode state.

SECOND STEPS: Using the Resetter

1. After you download the resetter, extract it and double click "servicetool.exe"

2. Load some papers in your printer and press the "Main" Button once, wait until the printing is done.

3. Then press "EEPROM Clear" button to clear EEPROM.

4. Then press EEPROM button and the printer will print some text.

5. Then power off the printer(sometimes you have to press twice the power button to turn off) and turn on again. and its done!

Read More...

Any Kind of Canon Printer Problems Call Us
+1-855-517-2433 (Toll Free)